Cornhole dimensions

Today, the official dimension and laws for the Cornhole boards have been officially set by American Cornhole Organization. They release the new Cornhole board plans, which should include a painted and polished wood having two feet in its width and with four feet in its length and exactly 24 inches x 48 inches. The board should also have 3 up to 4 depth inches and should be tilted with a set of legs at the end of a board to ensure that your board will have 12 inches off the ground and can be measured from its board surface.

The whole bags are being thrown at to cut into the end of the board in position to the center of hole. It is equidistant on both sides of your board and has a distance from each edge of about 12 inches. The center of hole is now cut having 9 inches for its distance from each end of the board.

Cornhole board plans

Corn hole plans

From the top

Cornhole plans

From the side

So are you planning to build a Cornhole that is base from the new set of Cornhole board plans? Here are things you need to do:

To build Cornhole boards, you need to construct two 48 by 24 inch of platforms that is made from ½ inch of plywood that can stand for about 12 inches at the back and 2 ½ up to 4 inches on its front. Now, gather all the needed supplies including the two pieces of the plywood that are measured 24 by 48 inches wherein four of it are 21 inches and the other four are measured 11 ½ inches.

Build now the platforms in which there is a need for you to construct two boxes with 2x4s and fasten the 21-inch board inside the 48 inch of board. Once you already complete the boxes, fasten now the plywood board to the top of the frame through using the 1 5/8 inch of screws.

The next thing you should do is add the legs. At one leg of your cornhole, you can make 3 ½ inches of radius and cut it with jigsaw. For you to attach the legs, turn your box upside down and lay each leg in parallel then flush it on its top corner. Mark now the vertical center of radius of each leg and drill for about ½ inch of hole through the legs and box. Attach the leg with carriage bolt, wing nut, and washer. Just ensure that the legs are square then tighten the bolts. Turn platforms at the right side upward and use the blocks to lift the platforms of 12 inches from table.

With your Cornhole board plans, make a hole at the center that is about 9 inches from top and 12 inches from its side. You can use the compass to draw the 6 inch of circle and use jigsaw for cutting. To get the best Cornhole board plans, finish it using the sand, paint and prime and make the desired design you want.

With Cornhole board plans, you will have assurance that you can create perfect Cornhole board.